Engineering Graphics 2018 Question Paper — Government College of Engi…
The 2018 Engineering Graphics previous year question paper (Government College of Engineering and Technology, Jammu), with every question and its marks.
- University: Government College of Engineering and Technology, Jammu
- Subject: Engineering Graphics
- Course: Engineering Graphics
- Year: 2018
- Paper: end-term
- Duration: 180 minutes
- Total marks: 100
Instructions
- Attempt five questions in all, selecting at least two questions from each section.
- Use of calculator is allowed.
- Assume any missing data.
Questions
SECTION-A
- Q1. Write freehand, in single-stroke inclined capital letters using ratio 7:5. NO FREEHAND LETTERING SHOULD BE DONE WITHOUT DRAWING GUIDE LINES. [20 marks]
- Q2. A regular pentagonal lamina, of 25mm side, rests on HP on one of its side such that it is inclined to the HP at $30^0$ and the side on which it rests, inclined at $45^0$ to the VP. Draw its projections in first angle. [20 marks]
- Q3. A right regular pentagonal Pyramid, side of base 25mm and height 50mm, lies on HP on one of its slant edges and has its axis parallel to VP. Draw its projections. [20 marks]
SECTION-B
- Q4. A right regular pentagonal prism, base edge 30mm and height 70mm, is held on HP on one of its base edges, such that its axis is parallel to VP and inclined to HP at $30^0$. An auxiliary horizontal plane cuts the prism, intersecting its axis at distance of 17mm from its top end. Draw its front view and sectional top view. [20 marks]
- Q5. A vertical cylinder of diameter 120 mm is fully penetrated by a cylinder of diameter 90 mm, their axis intersecting each other. The axis of the penetrating cylinder is inclined at $30^0$ to the HP and is parallel to the VP. Draw the top and front views of the cylinders and the curves of intersection. [20 marks]
- Q6. A cylinder of diameter of base 40 mm and height 50 mm is standing on its base on HP. A cutting plane inclined at $45^0$ to the axis of the cylinder passes through the left extreme point of the top base. Develop the lateral surface of the truncated cylinder. [20 marks]
- Q7. Draw front view, side view and top view of the figure A. Also dimension the views completely. [20 marks]
- Q8. Figure B shows isometric view of an object. Draw (a) Front View (b) Side View (c) Top view, and add all necessary Dimensions. [20 marks]
Related pages
Other years
- Engineering Graphics 2022 question paper — end-term
- Engineering Graphics 2022 question paper — end-term
- Engineering Graphics 2022 question paper — end-term
- Engineering Graphics 2022 question paper — end-term
- Engineering Graphics 2018 question paper — end-term
- Engineering Graphics 2018 question paper — end-term
- Engineering Graphics 2018 question paper — end-term
- Engineering Graphics 2018 question paper — end-term
- Engineering Graphics 2018 question paper — end-term